|My helmet was pre-drilled by the manufacturer for HANS Device|
anchors. What do I do?
your helmet manufacturer has followed the FIA 8858-2002 or 8858-2010
standard, or if they have followed our Helmet Anchor Installation
guidelines, all you need to do is go ahead and use the pre-drilled
There’s a ridge or air vent preventing me from following your Helmet Anchor Installation guidelines. What do I do?
anchor location positions have to be adjusted to suit helmet features
such as ridges, air vents, etc. In these situations, locating the hole
up to 1" rearward, or 1/4” up, down or forward is satisfactory. It is
very important that the holes are positioned symmetrically, so if you
move the location point on one side, do the same for the other. If in
doubt, call us.
Where do I find the FIA information?
For full details click here