These Racequip SFI 16.1 Latch and Link harness sets are perfect autocross and other types of racing that don't time out SFI ratings in 2 years.
The high quality, simple to operate latch and link is preferred by many drivers for its simplicity and ease of use. The system is also recommended for any type of dirt or off road use.
Camo Colored webbing.
All harness systems are constructed using drop-forged steel hardware for ultimate strength and reduced weight. All hardware is cadmium plated for added protection. We use only 3" premium polyester webbing and all belts are box-x pattern sewn to ensure uniform stitch length and strength. Belts and hardware are routinely tested to verify compliance with SFI 16.1 standards.
All of our harness sets feature a latch & link system to retain the belts. The latch & link system is distinguished by a pivoting "hammer," called a Duckbill, which locks all of the belts into place by snapping down into a detent. Both shoulder belts and the sub belt are hooked over the link; the link is inserted into the latch; the Duckbill is then brought down into and over the link, securely holding all of the pieces in place.
RaceQuip Latch & Link Harness Systems come as a "pull down" design. This means that the lap belts must be pulled down and away from the center latch mechanism to tighten.
All necessary mounting hardware is included with each belt set. Since our belts are "double adjustable", lengths are easily adjusted on either end for ease of installation. Using the included three bar slide you can mount the belts by either wrapping them around a rollbar or by bolting them in place.
Snap-in ends and eyebolts are sold separately if you want to install your belts in that manner.
NOTE: RaceQuip harness sets and seat belts are NOT D.O.T. / FMVSS 209/302 certified for on highway use. They are only to be used in racing vehicles off of public streets and highways. All racing harness sets are designed to be mounted in a race vehicle to a rollcage or harness bar.